Yard machine by mtd edger with 3.5 hp tecumseh engine

but the engines ran more like a piece of compared to before. the amount of waste that comes out the exhause was a lil less cause the fire was hotter. run them at over 200 degrees, they push it by saying it is more efficient. (figures don lie liar's figure)В Just like the first emissino engines. Don't believe anything the EPA slams down your throat.

Quite possibly true.В Why OHV in these size engines, You know It is primarily an EPA issue. I've even heard rumors now that theВ L-head engines actually produce more torque at a lower RPM than there supposedly more efficient OHV counterparts. Do you have any pics/diagrams for your method? I now need a tachometer to measure the rpms. I think I can raise the rpm by turning it in (CW) and lower it by turning it out (CCW). I'll have to pull the shield off to see but I seem to remember the governer adjustment mechanism is just a spring-loaded phillips screw. (At least that's my understanding of it all.) The snowblower engines are also meant to run at a fairly constant speed regardless of the load placed upon it. That is why diesel engines (high torque - low hp) can haul heavy loads (up hill) with out losing much speed but are very slow in accelerating to a given speed. Torque measures the ability of an engine to maintain a set speed given an increasing load. As I understand it, hp is necessary for acceleration, or the ability to increase speed. YourВ thoughts on torque vrs horsepower sound right for this type of application. I now have to borrow a tach and see if mine is in that range. Follow the above governorДЄdjustment procedure to complete the short block Solid link and spring to the governor lever and position To the same position as the original engine. TheД¬lamp must be removed from the governor rod and turned (tinnerman style) to be repositioned to work properly. vertical shaft enginesД«uilt prior to 1977 may require the governor clamp Hold the lever andД¬lamp in this position while tightening the screwДЇOR SHORT BLOCK INSTALLATIONS GOVERNOR ADJUSTMENT PROCEDURE Push the governor lever connected to the throttle In a direction that will force the throttle shaft open andДЄllow the governor follower arm to rest on the governor With the engine stopped, loosen the screw holding the

Yard machine by mtd edger with 3.5 hp tecumseh engine